Sub C Size 4.8V 2000Ma  Stick with LEads  

Read more less

3.2v 1.5Ah  4.8Wh  3 wire 

Read more less

Liteplan no longer make this item , however we have a supplier whom can still supply them to the  same spec but wont have a Liteplan label on them     https://www.liteplan.com/images/products/Batteries/NiCd/3-CD45-PT-AS.pdf

Read more less

0

Read more less

4.8V 4.0Ah NI-MH  LAHT C020F-Reversed 

Read more less

3 Cell battery pack   Model : Like  a 3DH4-0L4 Leads no amp connector  B003 Voltage : 3.6v Capacity : 4.0ah Weight : 390g Dimensions : 32.3 mm Diameter x 178 mm Long3DH4-0L4 3.6v 4.0Ah Ni-Cd battery for use in emergency lighting. Terminals : Red and black flying leads around 300 mm long Battery Type: High temperature nickel-cadmium battery (Ni-Cd) for use in emergency lighting. + Red wire - Black wire Sealed Rechargeable Battery KRMT33/62 r3c/st/tl 3DH4-0L4 3.6v High Temp D CD ---------------------------------------------

Read more less

IB Motion detecter sensor transformer HZK218C 77309055IR sensor: 13mm ELD 250W Infrared Sensor Switch Manufacturer SELF MPN HZK218C Primary 220 - 240v 50/60Hz Secondary 240v Dimmable No Minimum Wattage N/A Maximum Wattage 250w Outputs 1

Read more less

IB Motion detecter sensor transformer HZK218C 77309055IR sensor: 13mm ELD 250W Infrared Sensor Switch Manufacturer SELF MPN HZK218C Primary 220 - 240v 50/60Hz Secondary 240v Dimmable No Minimum Wattage N/A Maximum Wattage 250w Outputs 1

Read more less

15W LED Retrofit Geartray Top Hat Style 2000 Lumens 3K colour Temp Microwave and Corridor Function 5 year Warranty  215mm x 195mm x 40mm (fixing centres - 200mm)  

Read more less

Changeover Module On medium to large projects it can be advantageous to provide emergency lighting using a static inverter connected to a number of the existing mains luminaires. In these installations it is necessary for the normal supply and the static inverter supply to be selected by an automatic switching device within or external to the luminaire. Some suppliers offer a standard 230V AC change-over relay for this purpose but this ignores the fact that a free running static inverter is not tied to the grid frequency and will therefore be out of phase or in a worst case situation could be in anti-phase with the normal switched supply. When a relay tries to switch between these supplies there is a tendency for the relay to suffer from arcing between the normally open and the normally closed contacts resulting in a temporary short circuit between the two out of phase supplies. This will cause external circuit protection to operate (fuses and/or circuit breakers) and will ultimately destroy the relay. In extreme cases it can also damage the static inverter. The SIM240 static inverter module is designed to eliminate these switching problems. The SIM240 utilises two interposing relays for the two supplies and introduces a time delay of approximately 500m sec between breaking the normal supply and connecting the static inverter supply. This sequence is reversed upon restoration of the monitored 230 volt supply when the SIM240 immediately breaks the static inverter supply and then after a similar time delay reconnects the normal lighting supply. A dimming isolation facility is incorporated as standard for use with dimming ballasts to enable full light output to be achieved in the emergency condition. Datasheet

Read more less

  14.4V 1.6Ah 3+3 With Amp Connector  ChemistryNiCD (Nickel-cadmium) ConfigurationTwin Stick ConfigurationCell SizeSub C Cell (Cs)Width56Length286Depth28Weight545AMPH1.6Voltage14.4   Existalite (2+6) Cell 1.6Ah 14.4v Twin Emergency Battery Pack (Existalite)

Read more less

6v 4Ah D Size Stick , Ni-CD with Amp connector  Cross Reference B005 

Read more less